The cement ball mill is mainly composed of feeding part main bearing cylinder part transmission part (large and small gear device) discharge part (cylinder screen) basic part main motor hydraulic coupler slow transmission device coupling jacking device lubrication electronic control and so on.
1.Cylinder part: the cylinder part is the main component of the ball mill which is composed of the end cover at both ends and the cylinder body in the middle. In order to prevent the excessive wear of the end cover and the cylinder the lining plate is arranged inside the cylinder liner is cast into a stepped section the end liner has a lifting strip and the liner is fixed with bolts.
2.Main bearing: hydrostatic sliding bearing is used. It is a kind of bearing which has both dynamic pressure lubrication and static pressure floating effect. Before and when the mill starts and stops grinding high pressure oil is supplied to the bearing and the static pressure plays a role.
3.Transmission part: the transmission part includes large gear pinion shaft group (wheel device) gear cover and other parts. Large and small gears are made of alloy steel straight tooth transmission easy to adjust stable work small impact long life.
4.The base of the ground: the base of the ground marks the relative position of the anchor bolts of each component the elevation of the base surface and the load of each part. Including anchor bolts and related burying parts.
5.Slow drive: the slow drive is composed of motor planet reducer etc. with its own installation base plate. The device is used for the maintenance of the mill and the replacement of the liner. When the stop is more than 4 hours the material in the cylinder may caking and turning with the slow drive before starting the mill again to achieve the purpose of loosening the material.
6.Lifting device: the lifting device is composed of manual screw Jack and bracket etc.